If your Moto G Power screen has started to look a little tired, it’s time to replace it. But how do you know which part to remove and replace? This article will show you how to remove and replace a Moto G Power screen in minutes.

Remove the Moto G Power Screen.

Pour a pot of boiling water onto the screen and wait until it has boiled. Remove the battery cover and unscrew the screws on the back of the Moto G. Pry out the glass from around the edge of the moto g power screen replacement by using a credit card or sharp knife. Use pliers to pull off the old screen and replace it with the new one. Screw the screws back onto the battery cover and screw them in place again. Reattach the battery cover and screw it in place (be sure to torque it down). Put your phone into standby mode by pressing and holding power for about 10 seconds or until it goes off; then turn it on again and press power to turn it on (the phone will show ‘On’).

Remove: Place a pot of boiling water onto the screen, wait until it has boiled, remove screws from the back of Moto G, Pry out glass from around the edge, use a credit card or sharp knife to pry off the old screen, replace with a new one; Pliers: Pull off old screen, replace with the new one; Screw in screws back on to battery cover, screw in place.

Replace: Place the new screen in the same spot, screw back onto the battery cover, and screw in place.

Remove the Moto G Power Screen.

Remove the screws that hold the moto g stylus screen replacement to the motherboard. Disconnect the power cord from the Moto G Power Screen. Lift off the cover of the Moto G PowerScreen. Remove the battery cover (if present). Remove the glass panel on top of the Moto G PowerScreen (if present). Pry out all of the adhesives with a sharp object, so that you can remove it easily from behind (or remove it completely if using a tempered glass screen). Underneath, find and remove two screws (or use pliers to twist them out of place) and then remove the screen from its housing. Put back together as necessary by reconnecting all of the screws, battery cover, glass panel, and screwdriver positioning as needed to join in properly.

Remove and replace a Moto G Power Screen in Minutes.

Remove the cover of the Moto G Power phone. Disconnect the battery from the Moto G Power phone. Remove the screws that secure the screen to the phone body. Lift off the Moto G Power screen by using a screwdriver to pry it away from the phone body. Disconnect the video cord from the Moto G Power screen. Replaced: unscrew and remove the old screen, and replace it with a new one

How to replace the Moto G Power Screen

Disconnect the power cable from your Moto G Power phone parts xt2043-4. Open the case of your Motorola Mobility Phone and remove the bottom bezel (if there is no bezel, then just turn off the mobile device by unplugging it from a wall outlet). Pry out the old screen by gently pushing and pulling it out of its holder (If there is any adhesive left on top of the old screen, remove it with a damp cloth). Place the new screen in its place. Reattach the battery to Mobile Device and plug in power cable back into the wall outlet.

Conclusion

Removing and replacing a Moto G Power Screen in Minutes is an easy way to replace a lost or damaged screen. By following these simple steps, you can easily replace a Moto G Power Screen without any fuss.